Sunday, 23 February 2014

JimmyJib camera crane operating tips

You can sewa jimmy jib murah di jakarta surabaya operator/cameraman must be consulted at the planning stage regarding the location and use of the crane. TV industry safe practices professionals advise that, whenever a camera crane is employed, it should be operated by 2 different people - a cameraman and the assistant. It is particularly important in situations in which the jib could strike a man or women or an object, for an assistant to be able to stop the movement if any collision is imminent. Because on the severe effects of weather and wind, the jib must continually be operated by two people whenever it's used outdoors.

One man operation can be considered only in exceptional circumstances, on indoor locations where each shot might be rehearsed and recorded separately and you'll find no members of the public involved. This mode of operation is just permissible by prior negotiations with all the jib operator.


The standard jib kit can be built in sections up to and including length of 6m (arm reach). For a longer arm, additional sections must be added, including extra weights, cables as well as a heavy-duty base. These are not area of the standard kit and must possibly be booked separately. The Jib operator must be advised beforehand about the maximum length of jib arm that will be required. CLICK HERE to visit a table of jib sizes.


The crane arm, specifically in its long version, can be seriously affected by wind, producing many shots unusable. It are often unsafe to raise the provide to any height in solid winds. Provision must be made intended for securing the crane properly if it's to be left unattended, even for a short time of time. The advice with the crane operator must be used in these situations.


The standard size Jimmy Jib (up to 8m reach) is usually transported in an estate car or even a small van. The weight with the Jimmy Jib, including transport instances and counterbalance weights is approx 300 kg. Any car used have to be fitted with a cage or other safety device to counteract the load moving in an unexpected emergency stop. The 10m and 12m jib takes a larger vehicle, e. g. a 3. 5 tonne Transit van.


Rigging time for the standard jib (up to 8m) within an easily accessible location is 60 minutes. In difficult locations (e. g. up stairs) or where vehicles cannot get close to the running area, extra rigging time has to be allowed. The 10m and 13m reach Jib takes longer to rig and 2 hours ought to be allowed.

Moving between locations

If the ground is reasonably firm as well as level, with no steps or obstructions in the way, the crane can be transferred fully rigged. On other occasions, the crane can be somewhat dismantled and carried. Allow 30 minutes and at the very least 3 persons will be needed.


It is important that the operating position for your camera crane is firm as well as reasonably level. Boards must be used to prevent the tripod thighs or dolly wheels sinking about soft ground. Space is required BEHIND the crane for that counter-balance weights and the operator of a minimum of 2.

No comments:

Post a Comment